...
- Communicate effectively with the UI (Loui)- this will fail if the time offset with the LOUI computer difference between LOIS & LOUI computers is more than about 5 seconds.
- Have good time for the FITS headers- especially important for occultations and transits- time offset from reality on the LOIS computers should be much less than 1 sec.
This note describes how to evaluate and set up time services for the LOIS computers, especially the Centos 6.2 Linux hosts at DCT. These hosts are normally operated in headless mode, so command lines as described below are used. The UI (Loui) computers use Apple configuration (System Preferences) for the ntp setup, which are reasonably well known and not described further here. The level of timing accuracy required for these is much less in any case, since there is no relation to scientific data timing.
To maintain quality of service for time, (QoS), ntpd is used. The computers themselves have poor clock/calendar h/w- at the level of a very cheap watch- so you would need to check and reset time several times in the night if relying on a manual operation. Ntpd should start automatically when the computer is restarted, and remain up. The timecheck and st scripts will inform you if ntpd is not running. The timefix script, run as super user, will allow you to stop, start, or restart ntpd if you need to do that. There is also an operation called ntpdate which will access a remote timeserver and do a good time correction on a one time basis; this can be invoked with timefix also.
...
The st script is available on all lois computers, as are ntpd, ntpdate and ntpq. Timecheck and timefix are currently on deveny only.
NTPD & NTPDATE
Ntpd is invoked with a simple
/usr/sbin/ntpd
and is immediately placed in the background. This can only be done as superuser. Ntpd will attempt to contact servers in the ntp.conf list and establish time synchronization with them. The progress of this synchronization is described by a parameter called reach, which begins at 1 with first contact- complete synchronization is associated with the value 377. The synchronization process usually requires no more than about 15 minutes to complete. It accelerates this process in some cases to use ntpdate initially to get the time on the host close to reality. Otherwise, since the process of moderating the system clock is done slowly, the difference in time between the host and the several time servers, a variable called the offset, can take a surprisingly long time to become reasonable.